I picked up one of their "folding" style levers.
For the life of me, I can't figure out how to get the stock lever off the brembo master! The adjuster knob seems to be the culprit, but there doesn't seem to be an easy way to remove it.
Somebody help!
--Justin
This might help...apparently some pins punch out and some are screws. Good luck.
http://www.ducati.ms/forums/showthread.php?p=496332
Quote from: LongDogRacing on November 09, 2008, 08:49:30 AM
I picked up one of their "folding" style levers.
For the life of me, I can't figure out how to get the stock lever off the brembo master! The adjuster knob seems to be the culprit, but there doesn't seem to be an easy way to remove it.
Somebody help!
--Justin
There is a tiny pin in the adjuster knob. Knock it our with a roll pin punch and a hammer, then remove the C/D clip fromt he primary pivot/axle and the lever will fall right off.
Thanks guys! Looks like I wasn't alone in having trouble with this thing!
http://www.visordown.com/forum/forummessages/mps/utn/237892/v/1/cp/1/
and once you lose the pin (you will... if not today, give it time) just replace with safety wire.
Also, do yourself a favor and buy a rebuild kit because once you fall, the lever RARELY breaks, but what does break is the little "hat" inside that holds the plunger in place (which pushes the piston to make you anti-go). They're cheap... www.yoyodyneti.com tell Fred I sent you from here... (so he knows his advertising dollars work)